Sorry, it took me a while to get back. Part of the delay is for being busy, another big part was contributed by the fact that we seem to be aiming at a moving target here: for a while, it seemed like I could hide the problem by using port forwarding instead of port triggering, but then, it came back. Later, it appeared to work even with port triggering, and today, it failed again. I am afraid the results are generally not repeatable. I am including a log file of an attempt where "registration failed" immediately upon start of Ekiga. Since the last successful call, there have been no changes to the configuration of Ekiga, nor to the router. The file has only about 250 lines, so no "tail -n 1000" was required. If I knew enough about SIP (or about STUN?) to understand the log file, I could probably write my own program rather than use Ekiga, but I have no experience with either protocol. I hope someone can make sense of the log and point me to something helpful. Regards, Andreas > -----Ursprüngliche Nachricht----- > Von: "Eugen Dedu" <Eugen Dedu pu-pm univ-fcomte fr> > Gesendet: 18.08.09 18:56:09 > An: Ekiga mailing list <ekiga-list gnome org> > Betreff: Re: [Ekiga-list] registration failure > Could you start ekiga like this: > ekiga -d 4 2>output > do your job, and when the problem arrives, ctrl-c ekiga and send us the > latest ~1000 lines from the output? > > Eugen > > Andreas Freiherr wrote: > > Bent, > > > > my DSL provider may interrupt the connection once per day, in the early morning hours. At that time, I expect my public IP address to change (the WAN interface of my router does use DHCP), but not normally during the rest of the day. Also. while the Ekiga calls dropped, I usually had a chat session open, including webcam, and there was no problem with these data streams. And no, I don't think bandwidth is an issue here, because the voice connection was quite usable while it lasted. No dropouts, better quality than international phone calls through cheap call-by-call providers. > > > > Even if my address would change, Ekiga should find out (using STUN) at least after I restart the program, right? - But restarting Ekiga did not allow me to register again. > > > > Andreas > > > >> -----Ursprüngliche Nachricht----- > >> Von: "Bent Bagger" <bbagger gmail com> > >> Gesendet: 17.08.09 18:15:02 > >> An: Ekiga mailing list <ekiga-list gnome org> > >> Betreff: Re: [Ekiga-list] registration failure > > > > > >> Andreas Freiherr wrote: > >>> Hello Yannick / others, > >>> > >>> It would seem sometimes it works, but often it does not. Yesterday, I got disconnected in the middle of a call and was not able to register even after restarting Ekiga. > >>> > >>> Note: settings must have been OK; I had an active connection, and I did not change anything after loosing it. > >>> > >>> Today, it worked again -- without changing any settings. Once. Then, I got disconnected, and right now, I am still unable to register to Ekiga.net (timeout). > >> Just a thought: Could it be that your external IP address has changed? > >> It is not said explicitly, by it appears that you have a dynamic IP > >> address. It might be that the DHCP lease expired during the call and > >> that you got another IP from your ISP's DHCP server. I don't know the > >> STUN mechanism well enough to be able to say that it should be able to > >> follow such a change in IP address. > >> > >> Bent > >> > >> _______________________________________________ > >> ekiga-list mailing list > >> ekiga-list gnome org > >> http://mail.gnome.org/mailman/listinfo/ekiga-list > >> > > > > -- > > Reboot!? - No thanks. I'm using Linux and OpenVMS. > > > > ______________________________________________________ > > GRATIS für alle WEB.DE-Nutzer: Die maxdome Movie-FLAT! > > Jetzt freischalten unter http://movieflat.web.de > > > > _______________________________________________ > > ekiga-list mailing list > > ekiga-list gnome org > > http://mail.gnome.org/mailman/listinfo/ekiga-list > > > > _______________________________________________ > ekiga-list mailing list > ekiga-list gnome org > http://mail.gnome.org/mailman/listinfo/ekiga-list -- Reboot!? - No thanks. I'm using Linux and OpenVMS. ______________________________________________________ GRATIS für alle WEB.DE-Nutzer: Die maxdome Movie-FLAT! Jetzt freischalten unter http://movieflat.web.de
Attachment:
ekiga.log
Description: Binary data