Re: Printer not working

["Michael Valcarcel" <mvalcarcel home com>]

When you guys installed Redhat 6.1 did it give you the option of setting up
a printer during the install?
   -=aRRaKis=-
(Michael Valcarcel)

-----Original Message-----
From: Allan Andersen <swoop-dk@altavista.net>
To: Gnome General <gnome-list@gnome.org>
Date: Tuesday, January 25, 2000 5:32 PM
Subject: Re: Printer not working


>Robert Krueger wrote:
>
>> In the 6.1 "Gotcha's and Workaround" section of the RedHat site,
>> section 6.16 is supposed to deal with this issue, which I installed
>> manually into the /etc/conf.modules file.  I also installed the modutils
>> RPM (I hope...) as it said.  Before I did this, Gnome did not see any
>> printer attached to lp0, lp1, or lp2, but now it sees one attached to
>> lp0, so I have to assume the modification was successful to this point.
>> When I try to print an ASCII test page, I hear it going to disk, but no
>> lights blink on the printer, and I get no errors.  It says something
>> about sending the file to the print spool.  That's about it.
>> Any Help would be greatfully appreciated.
>>
>
>Hi Robert !!
>
>What did you write in the file /etc/conf.modules. It's becouse I have
>the same problem with it couldn't see any printer attached to any
>lpx. By the way I use HP DeskJet 895cxi.
>
>Allan
>
>
>--
>        FAQ: Frequently-Asked Questions at http://www.gnome.org/gnomefaq
>         To unsubscribe: mail gnome-list-request@gnome.org with
>                       "unsubscribe" as the Subject.
>